Boat Specifications

Make: Dyna-Ski Boats
Model: 20' Closed Bow
Year: 2019
Length: 20 ft. 1 in.
Type: Bowrider Boats
Listing: 2009359
Buyer's Tools:

The Dyna-Ski 20' Closed Bow boat is a much refined and improved version of the original Hydrodyne 20' Closed Bow Boats designed in the early 1980's and built for many years. The new style Dyna-Ski has taller sides and is longer. Dyna-Ski 20' Closed Bow boats are all built the same so the boats are all built and designed to be anything from a single to a triple over the lifetime of the boat right from the start. There are differences between the Dyna-Ski boats as they are initially rigged but this model can have its configuration changed with minimal rework of the boat hull. So a single Dyna-Ski 20' Closed Bow can be changed into a twin or even a triple motored boat without changes to the hull other than holes to mount the motors. The rigging for the motors and steering of singles, twins and triples will likely be completely different though.

This modern revision of the old tried and true Hydrodyne Outboard closed bow boat features an additional 9" of hull length which means the boat has more load capacity. (about 5%). The single, twin and triple motored applications float noticeably higher in the water than the older style boats. A low rider triple motored boat is not good! The driver and passengers also sit about 18" further forward in this boat compared to the older style of boats so the driver can see better and less weight is needed in the nose of the boat. All our boats have higher sides than the older boats for a dryer ride. The additional length also means the Dyna-Ski boat does not squat as much with bigger twin and triple applications. This special purpose model has a lot of additional material in the areas that need it for this type of usage. The stringers and floor is fully encapsulated unlike the older style of boats.
Beam: 7 ft. 0 in.
Standard features:
Specs
Centerline 20'1"
Beam 84"
Max HP Unlimited


Features
3+" transom
72" motor mounting area
Single color gel coat
An adjustable throttle pod
Driver's bucket seat
Rear facing passenger bench seat
Passenger foot brace
2 7/8" rear mounted ski pylon
40+ gallon front fuel tank with one
Two or three fuel pickups
Pre run motor fuel lines
Plug in running lights
Pop up mooring cleats
Heavy duty bow and stern eyes
Carpeted floor
Rub rail
Bilge pump and flotation
A windshield is available on these models.
Dyna-Ski boats have a five year limited hull warranty.


Optional features:

Dyna-Ski Single Motor Options
Rear mounted fuel tank (front tank deleted)
Swim Platform
Boarding Ladder


Teleflex
Hydraulic Steering with a 1.7 Pump
Tilt Helm
Power assist
Throttle & Shift Cables (may require adapters)


Livorsi
Two Lever Controls for a single motor
GPS Speedometer


Evinrude
Standard Control rigging kit
Binnacle Control rigging kit
I-Con Controls and Engine Monitoring for Evinrude V-6 Engines
GPS Speedometers (wired stand alone)


Mercury
Standard Control rigging kit
Binnacle Control rigging kit
Mercury Smart Craft Controls and Monitoring for some models of Mercury Motors


Dyna-Ski Twin Motor Options


Teleflex
Hydraulic Steering with a 1.7 helm, cylinder and tie bar motor specific
Tilt helm
Power assist
Throttle & Shift Cables (may require adapters)


Livorsi
Four Lever Control
GPS Speedometer


Evinrude
Dual Binnacle Control Rigging Kit
I-Con Controls and Engine Monitoring for Evinrude V-6 Engines
GPS Speedometers (wired stand alone)


Mercury
Dual Binnacle Control Rigging Kit
Mercury Smart Craft Controls and Monitoring for Mercury Motors


Yamaha
Dual Binnacle Control for Evinrude or Mercury


Dyna-Ski Triple Motor Options


Teleflex
Hydraulic Steering with a 2.4 helm, two motor cylinders and two tie bar kit that is motor specific
Tilt helm
Power assist
Throttle & Shift Cables (may require adapters)


Livorsi
Six Lever Control
GPS Speedometer


Evinrude
Triple Rigging Kit
I-Con Controls and Engine Monitoring for Evinrude V-6 Engines
GPS Speedometers (wired stand alone)


Mercury
Triple Rigging Kit
Mercury Smart Craft Controls and Monitoring for Mercury Motors


Yamaha
Triple Binnacle Control for Evinrude


Motor Drilling
Narrow Spacing for smaller engines
Wider spacing for three big block engines


Dyna-Ski Options for all 20' Closed Bow Versions
Multicolor Hull
Three Color Interior
Additional Seating
Non-skid Flooring
Snap On Cock Pit Cover
Mooring Cover
Motor Rigging for all brands
Motor Installation for all brands
Water Ready and tested boats


Trailers
Single Axle with brakes
Tandem Axle with brakes (required for multiple engines)
Bow Stops
Vertical Side Guides
Additional capacity trailer
Galvanized Trailer for salt water use


KW Show Ski Equipment
KW Trick Release (one to five pins & HD models)
KW Straight Boom
KW Extended Pylon (replaces standard rear mounted Dyna-Ski pylon)


Barefoot International
Barefoot International V-Drive Boom (this is the recommended one for use on Dyna-Ski boats with a pylon just in front of the motor well)
Barefoot International Height Adjuster
Barefoot International w2923 Tower
Barefoot International w2906 Board Racks
Barefoot International Fat Sac for the bow under the seats
Barefoot International Fat Sac between the front seats
Barefoot International Fat Sacs for under the sun deck
Barefoot International pumps for filling and emptying Fat Sacs


Miscellaneous
Rope Guards
Batteries
Battery Trays
Weight under the floor (cannot be removed later)
Speaker Wiring
We strongly suggest if you want a entertainment system in your boat that you buy it locally so you have someone local to service the unit. Customers desires vary so widely it is nearly impossible to list all the stuff people have installed in their boats.

Contact DynaSki

Contact by Email

First name:
Last name:
Email:
Phone:
Message: * Indicates Required Field

Contact by Phone

Contact by Mail

DynaSki
170 West
Draper, UT 84020
View our other classifieds listings
Page Views: 430

Loading...